0 Mursten Brick 4 x 4 Corner with 1 Slot Left 0 Name: u8009c.dat 0 Author: N. W. Perry [Plastikean] 0 !LDRAW_ORG Unofficial_Part 0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt 0 BFC CERTIFY CCW 0 !CATEGORY Brick 0 !KEYWORDS Automatic Binding Brick, Lego Mursten 0 !HISTORY 2022-03-27 [MagFors] Studs without logo
Size: 1252 bytes
Submitted by: Plastikean
Not sure "left" or "right" are the best qualifiers, but I have nothing better to offer...
Agreed. This was done to match nomenclature of existing slotted parts, but it is fairly arbitrary.
Using only rect.dat primitives creates lots of duplicated edge lines.
Obvious T-junctions that could be avoided.
Is it correct to use the regular stud.dat here? It will generate a logo on studs.
Maybe use stud26 instead?
Slotted bricks such as these would not have had stud logos, no. And along with the geometry concerns, it would seem in order to revise the whole range of Mursten-era parts, as I did not attempt to make any improvements to those.
Submitted by: MagFors
Studs without logo
Existing certification-votes were deleted.
No comments were posted with this review.