Unofficial File parts/s/67908s01.dat
part image
File Header:
0 ~Figure Arm with Friction Pin for Minifig Hand, without Patternable Surface
0 Name: s\67908s01.dat
0 Author: Gerald Lasser [GeraldLasser]
0 !LDRAW_ORG Unofficial_Subpart
0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt

0 BFC CERTIFY CCW

Status:
1 'hold' vote. (HN)
Size: 34523 bytes
Reviewers' certifications:
MagFors=hold
Required (unofficial) subfiles:
(none)
Related (unofficial) subfiles:
File reviews and updates:
At Wed May 27 13:00:01 2020, the file was initially submitted.
Submitted by: GeraldLasser
At Mon Jun 8 22:00:02 2020, a new version of the file was submitted.
Submitted by: GeraldLasser
At Mon Jun 22 19:50:02 2020, the following review was posted:

Reviewer: MagFors
Certification: novote
Comments:
Typo "Printeable".

I don't like subfiles using the word " without pattern" or " without print" since they show up when I search for "pattern" or "print".
I prefer "without surface" instead.

At Tue Aug 11 18:30:01 2020, the following review was posted:

Reviewer: mkennedy
Certification: novote
Comments:
Might you able to use edge and ring primitives around the hole where the hand enters?

At Wed Oct 28 10:45:02 2020, a new version of the file was submitted.
Submitted by: GeraldLasser
Comments:
renamed

changed hand attachment point.

@mkennedy: I do not use a ring/edge prim as the outside of the hand is constructed of quads, when Prim-substituion kicks in, this does not look good then and produces artefacts

Existing certification-votes were deleted.
At Sat Nov 28 10:10:02 2020, the following review was posted:

Reviewer: MagFors
Certification: hold
Comments:
You have 8 quads near coplanarity (1.3-2.6 degrees) resulting in no good condlines showing up, or disappearing to soon.
And you also already have condlines going across these coplanar quads, but with bad control points. I think they should be split into convex triangle pairs.

I think you should add an ering prim, where the arm meets the friction pin prim.