Unofficial File parts/s/61068s02.dat
part image
File Header:
0 ~Slope Brick Curved  2 x  4 without Top and Back Patternable Surfaces
0 Name: s\61068s02.dat
0 Author: Massimo Maso [Sirio]
0 !LDRAW_ORG Unofficial_Subpart
0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt


0 !HISTORY 2022-04-11 [MagFors] Closed thin gaps

0 // Primitives
Needs more votes. (CN)
Size: 3056 bytes
Reviewers' certifications:
Required (unofficial) subfiles:
Related (unofficial) subfiles:
File reviews and updates:
At Thu Apr 7 04:40:01 2022, the file was initially submitted.
Submitted by: Sirio
Subparted for patterns

At Thu Apr 7 21:05:01 2022, the following review was posted:

Reviewer: MagFors
Certification: hold
Gaps in the sides of this part. I think we should correct the main parts too, 61068 and 88930.
Want me to do that?

At Fri Apr 8 23:25:01 2022, the following review was posted:

Reviewer: Sirio
Certification: novote
if you think you can do it, go ahead.

I had thought about it a bit but I didn't find a solution unless I increased the height of the front face.

In reality the cylinder should also be standardized with those of 11477 and 15068. These have a much smaller gap, but are different from each other for rounding, and even between one side and the other of the same part or between chrd and edge there is a difference.
Then all the derived parts are to be redone.
At Mon Apr 11 21:05:01 2022, a new version of the file was submitted.
Submitted by: MagFors
Closed thin gaps.

Existing certification-votes were deleted.
At Tue Apr 26 20:30:01 2022, the following review was posted:

Reviewer: MMR1988
Certification: certify
No comments were posted with this review.