Unofficial File parts/s/23422s01.dat
part image
File Header:
0 ~Handle for Pole 32 with Shaft and Helical Groove - Half
0 Name: s\23422s01.dat
0 Author: Massimo Maso [Sirio]
0 !LDRAW_ORG Unofficial_Subpart
0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt

0 BFC CERTIFY CCW

0 // Cylinder
0 // Fase
Status:
Needs more votes. (X)
Size: 10748 bytes
Reviewers' certifications:
(no current reviews for this file)
Required (unofficial) subfiles:
(none)
Related (unofficial) subfiles:
Handle for Pole 32 with Shaft and Helical Groove
Status: 1 subfile isn't certified. (SX)
Download: parts/23422.dat
File reviews and updates:
At Sat Nov 25 15:00:01 2017, the file was initially submitted.
Submitted by: Sirio
At Sat Nov 25 19:05:00 2017, the following review was posted:

Reviewer: Philo
Certification: novote
Comments:
It would be better to use some chrd primitives to match outer cylinder cylinder, thus avoiding gaps when using hi-res primitive substitution (LDView). Maybe also a ndis around inner cylinder, but since this one is already a 48-prim it's less useful.

At Mon Nov 27 10:45:00 2017, the following review was posted:

Reviewer: Philo
Certification: novote
Comments:
Actually since this part is not transparent, it would be much better to make inner and outer cylinders undrilled. I would even ditch the cylj4x10.dat primitive and make a R4 cylinder going into outside cylinder.

At Sat Dec 2 16:05:00 2017, a new version of the file was submitted.
Submitted by: Sirio
Comments:
Introduced simplifications in the design of the handle and the intersection with the central cylinder.

Existing certification-votes were deleted.
At Sun Dec 17 10:25:00 2017, the following review was posted:

Reviewer: MagFors
Certification: hold
Comments:
Some cond-lines on the internal bump is not correct.
I don't understand the need for a hi-res inside.
Overlapping surfaces in the bend in the handle. The two sloping cyls could be replaced by only one cyls.
At Fri Dec 22 10:00:00 2017, a new version of the file was submitted.
Submitted by: Sirio
Comments:
The internal cylinder has 48 sides to keep the same shape of the 3 notches and not having to change between the central and the lateral ones.
I understand that it is excessive to use a high-definition primitive for such a small cylinder, but it seems more correct to maintain the rotational symmetry of the component.

Existing certification-votes were deleted.