Unofficial File parts/19730.dat
part image
File Header:
0 Minifig Helmet Square Head
0 Name: 19730.dat
0 Author: Magnus Forsberg [MagFors]
0 !LDRAW_ORG Unofficial_Part
0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt

0 BFC CERTIFY CCW

0 !CATEGORY Minifig Headwear
0 !KEYWORDS Minecraft

0 !HISTORY 2016-03-18 {LEGO Digital Designer} Original part shape
0 !HISTORY 2019-07-20 [MagFors] File preparation for LDraw Parts Tracker

Status:
Needs admin review. (CCN)
Size: 5646 bytes
Reviewers' certifications:
Holly-Wood=certify
MMR1988=certify
Required (unofficial) subfiles:
(none)
Related (unofficial) subfiles:
(none)
File reviews and updates:
At Sat Jul 20 15:15:01 2019, the file was initially submitted.
Submitted by: MagFors
At Fri Oct 1 19:40:01 2021, the following review was posted:

Reviewer: MMR1988
Certification: certify
No comments were posted with this review.

At Fri Oct 8 08:40:01 2021, the following review was posted:

Reviewer: Holly-Wood
Certification: hold
Comments:
1 16 0 9.1045 14.731 1.25 0 0 0 0 -9.1045 0 1 0 rect3.dat

overlaps with the head 19729

The side walls are 2.75 LDU the front and back wall 3 LDU

At Fri Oct 8 10:40:01 2021, the following review was posted:

Reviewer: MMR1988
Certification: hold
Comments:
Willy is right, i have not recogniced this.
But it is not just the one rect, all three strips collide with the head.

At Sat Oct 9 12:35:01 2021, the following review was posted:

Reviewer: MagFors
Certification: novote
Comments:
I don't have this part.
I can adjust the left/right supports, to be at +/-15 ldu, but how about the rear support?

There's no support on the front surface, and that surface is at 15.125 ldu.
Should I move the entire helmet so that the inside of the front surface end up at 15 ldu?
Or is the inside of the cavity offset?

I'm guessing the front side is thicker than the left/right/rear sides.

At Sat Oct 9 16:15:01 2021, the following review was posted:

Reviewer: Holly-Wood
Certification: hold
Comments:
Would offset the cavity as suggested and make the front wall thicker, keeping the origin as it is.

At Sat Oct 9 18:25:01 2021, a new version of the file was submitted.
Submitted by: MagFors
Existing certification-votes were deleted.
At Sun Oct 10 11:20:01 2021, the following review was posted:

Reviewer: Holly-Wood
Certification: certify
No comments were posted with this review.

At Sun Oct 10 16:45:01 2021, the following review was posted:

Reviewer: MMR1988
Certification: certify
No comments were posted with this review.