Unofficial File p/bowlball.dat
part image
File Header:
0 Technic Ball Joint 12.81L with Bowling Ball Holes
0 Name: bowlball.dat
0 Author: Santeri Piippo [arezey]
0 !LDRAW_ORG Unofficial_Primitive
0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt

0 BFC CERTIFY CCW

Status:
3 subfiles aren't certified. (CSSSN)
Size: 693 bytes
Reviewers' certifications:
MagFors=novote
fwcain=certify
mkennedy=novote
Required (unofficial) subfiles:
Related (unofficial) subfiles:
(none)
File reviews and updates:
At Fri Jun 10 12:40:09 2011, the file was initially submitted.
Submitted by: arezey
Comments:
New "bowling ball"-style ball joints I found in http://www.bricklink.com/catalogItemInv.asp?S=2194-1

I split the ball into the main segment half and four "caps", this is required to model mid-beam joints properly. This file is a "complete assembly", for lack of a better term. Going to use these primitives in the near future.

At Sat Jun 11 14:30:06 2011, the following review was posted:

Reviewer: MagFors
Certification: novote
Comments:
Why isn't this first file called "bowlball1.dat"?

At Fri Jul 1 03:55:01 2011, the following review was posted:

Reviewer: mkennedy
Certification: novote
Comments:
Are the caps similar enough to use single subpart?

At Mon Apr 29 23:40:01 2019, the following review was posted:

Reviewer: fwcain
Certification: hold
Comments:
there are small gaps at the far ends of the paired holes, as if the disc primitives at the far ends were rotated slightly differently than the tunnels/finger-holes...
At Sat Jun 1 20:25:01 2019, the following review was posted:

Reviewer: fwcain
Certification: certify
Comments:
Upon further investigation, it appears that the flaw I found is actually with the "bowlball2.dat" sub-file...

Transferring my "Hold" vote appropriately...